Beurer MPE 100 - Manual (Page 16)

16
• Do not use any chemical or abrasive cleaning agents.
• Ensure that no water enters the device. If this should happen, reuse the device only when it
has fully dried out.
• Do not submerge the base station and mains adapter in water or any other fluids.
6. What if there are problems?
Problem Possible cause Solution
Hand-held device will
not switch on.
Mains adapter not plugged in Insert the mains adapter into the
socket.
No voltage at mains socket Check your fusebox.
Hand-held device not connected to
base station.
Connect the hand-held device to
the base station.
7. replacement parts and wearing parts
Replacement parts and wearing parts are available from the corresponding listed service
address under the stated material number.
replacement part Material number
Fine sapphire cone 163.301
Coarse sapphire cone 163.302
Felt cone 163.303
sapphire wheel (fine) 163.304
Sapphire wheel, coarse 163.305
Cylindrical cutter 163.306
Flame-shape cutter 163.307
Sapphire cutter, round 163.308
Nail cutter 163.309
Sandpaper attachment 163.310
Single-use attachments, 30 units 163.311
Protective cap for nail dust 163.312
Mains adapter 163.313
8. Disposal
Observe the local regulations for material disposal. Please dispose of the device in accor-
dance with EC Directive – WEEE (Waste Electrical and Electronic Equipment).
If you have any queries, please contact the appropriate local authorities.
9. technical Data
Model no. MPE 100
Speed Up to 20,000 rpm
Power supply Input :100 – 240 V AC, 50/60 Hz, 1.2 A
Output: 15 V DC, 2.3 A