Beurer FCE 79 - Manual (Page 8)

8
4.2 Installation
You can attach the FCE 79 cosmetics mirror either to a smooth surface (e.g. glass or tiles) using the suction
caps, or to a wall using the screws.
Option 1: Installation on smooth surfaces using suction caps
WARNING
If you are using the suction caps to install the cosmetics mirror, make sure that there are no objects below it
that can be easily broken or scratched. The suction of the caps may decrease over time. Therefore check reg-
ularly that the mirror is attached securely.
1. Moisten the suction caps with a little water.
2. Attach the cosmetics mirror to a smooth surface
that is clean and free of grease.
Option 2: Wall fastening with screws
1. Mark the positions of the screws using the sup-
plied template. Drill holes at the points marked. In-
sert the three wall plugs into the holes. Then, screw
the screws into the wall plugs. Make sure that the
screws protrude at least 3 mm from the wall.
2. Hang the cosmetics mirror on the screws you have
inserted.
5. Operation
To switch the light on, press the symbol firmly.
To switch the light off, press the symbol firmly
again.
The light switches off automatically after
10 minutes.