Besafe iZi Kid i-size - Manual (Page 3)

10 11
! It is NOT ALLOWED to mount the seat in a front
passenger seat WITH AN ACTIVATED AIRBAG.
Crucial parts
1. Adjustable head rest
2. Shoulder straps (2x)
3. Harness buckle
4. Body hugger
5. Front brace
6. Central adjuster
7. Recline lever
8. Ratchet for front brace
9. Cap ISOfix connector (2x)
10. Switch for ISOfix connectors (2x)
11. Floor support
12. Height adjuster floor support
13. Floor support height indicator
14. Release handle head rest
15. Floor support position indicator
16. ISOfix car anchorage (2x)
17. ISOfix insertion clips (2x) (bottom side)
18. ISOfix connectors (2x)
19. ISOfix indicators (2x)
20. ISOfix release button (2x)
Preparing to install
Rearward-facing: ISOfix installation
1. The seat can only be installed rearfacing in
vehicles equipped with ISOfix anchorage points.
2. When mounting in the back seat of the vehicle, push the
front seat of the vehicle forward as much as possible.
3. When mounting in the front seat of the vehicle, adjust the
back rest into an upright position.
4. Positioned in the front seat of the vehicle, you should
position the seat against the dashboard.
5. If it’s not possible to position the seat against the dashboard,
position the seat as far as possible from the dashboard.
6. Find the ISOfix anchorage points in the vehicle. (21)
7. If your vehicle is not equipped with ISOfix insertion clips insert
these to make installation easier. (22)
8. You can find the ISOfix insertion clips under the base of the
seat or delivered separately with the seat.
9. Install the front brace by sliding the two pins into the oval tube
under the front side of the seat. Move the front brace inwards
with the ratchet. The ratchet is used to adjust the front brace in
both directions. Slide the switch on the ratchet up or down to
change direction. 23)
10. Pull both ISOfix connectors as far out as possible. (24)
11. The switch will go into the lowest position and locks the
ISOfix connectors.
12. Remove the caps from the ISOfix connectors by pressing down
the ISOfix release buttons. (25)
13. Fold down the floor support before you install the seat in your
vehicle. (26)
14. Place the seat sideways into the car with the front brace
towards you.
15. Turn the seat into the right position (with the front brace
against the back rest).
16. Click the ISOfix connectors in the ISOfix anchorage of the
vehicle. (27)
17. Make sure that all indicators on both sides are green. (28)
18. Move the front brace outwards with the ratchet. Continue
tightening until the brace is pressed well into the back rest of
the vehicle seat. (29)
19. Remove the cap around the floor support. An alarm sound will
start and stop when the seat is installed correctly with the floor
support in contact with the floor of the vehicle seat. (30)
20. Adjust the floor support so it is in contact with the floor of the
vehicle. (31)