Besafe iZi Combi X4 ISOfix - Manual (Page 3)

12 13
! It is NOT ALLOWED to mount the seat in a front
passenger seat WITH AN ACTIVATED AIRBAG.
Crucial parts
1. Adjustable head rest
2. Shoulder straps (2x)
3. Harness buckle
4. Body hugger
5. Front brace
6. Central adjuster
7. Reclining lever
8. Belt guiding hook
9. Ratchet for front brace
10. Cap ISOfix connector (2x)
11. Switch for ISOfix connectors (2x)
12. Wedge
13. Floor support
14. Height adjuster floor support
15. Floor support height indicator
16. Belt clamp (2x)
17. Release handle head rest
18. Floor support position indicator
19. ISOfix car anchorage (2x)
20. ISOfix insertion clips (2x) (bottom side)
21. ISOfix connectors (2x)
22. ISOfix indicators (2x)
23. ISOfix release button (2x)
Preparing to install
Rearward-facing: ISOfix installation
1. The seat can only be installed rearfacing in
vehicles equipped with ISOfix anchorage points.
2. Remove the wedge. (24)
3. When mounting in the back seat of the vehicle, push the front
seat of the vehicle forward as much as possible.
4. When mounting in the front seat of the vehicle, adjust the back
rest into an upright position.
5. Positioned in the front seat of the vehicle, you should position
the seat against the dashboard.
6. If it’s not possible to position the seat against the dashboard,
position the seat as far as possible from the dashboard.
7. Find the ISOfix anchorage points in the vehicle. (25)
8. If your vehicle is not equipped with ISOfix insertion clips insert
these to make installation easier. (26)
9. You can find the ISOfix insertion clips under the base of the
seat or delivered separately with the seat.
10. Install the front brace by sliding the two pins into the oval tube
under the front side of the seat. Move the front brace inwards
with the ratchet. The ratchet is used to adjust the front brace in
both directions. Slide the switch on the ratchet up or down to
change direction. (27)
11. Pull both ISOfix connectors as far out as possible, by pushing
the grey buttons on top of the base. (28)
12. Remove the caps from the ISOfix connectors by pressing down
the ISOfix release buttons. (29)
13. Click the installation clips on the ISOfix connectors. (30)
14. Fold down the floor support before you install the seat in your
vehicle. (31)
15. Place the seat sideways into the car with the front brace
towards you.
16. Turn the seat into the right position (with the front brace
against the back rest).
• Make sure you can fit no more than one finger between the
harness and your baby (1 cm).
• If in doubt, consult either the car seat manufacturer or
the retailer.