Beisler 739-23-1 Service Manual - Manual (Page 38)

Adjustment of setting
–
To select a direction, press the corresponding key.
Key “1": X position
Key ”2": Y position
Example: Change of X position
– Press key “3".
Press ”
↓
“ or ”“ key.
The needle position is moved in the selected direction and relative
to the material clamp in steps of 1/10 mm .
The last three digits of the display indicate the distance
from the initial position.
Or
–
Press key “4".
Press ”
↓
“ or ”“ key.
The needle position is moved in the selected direction and relative
to the material clamp in steps of 5/10 mm .
The last three digits of the display indicate the distance
from the initial position.
– Press “OK”.
The new position is saved.
– Press “ESC”.
The system returns to the programme for basic settings (300).
– Re-install sewing foot and blades.
3-38