BECKHOFF CP68xx - Manual (Page 8)

Product Description
Pin Signal Pin Signal
1 5V 3 D+
2 D- 4 GND
X 104 USB1, USB2
USB ports
USB Type-A twin circuit board mounting
(FCI 72309-0030B USB Double Receptacle
A-Type)
Connector description
DVI (Digital Visual Interface)
DVI-D The DVI connection (X 101) is used for transferring the video signal from
the Industrial PC to the Control Panel.
The purely digital part (DVI-D) is supported.
Power supply
Power supply The power supply for the Control Panel is established via the Cage clamp
socket (X 102).
USB interfaces
USB input The Control Panel is connected with the Industrial PC via the USB1.1 port
(X 103, connector type B) .
USB1.1 standard with a maximum data rate of 1.5 or 12 Mbps is
supported.
USB1 – USB2 The two USB1.1 interfaces (X 104, connector type A) are used for
connecting peripheral devices with USB connection.
USB1.1 standard with a maximum data rate of 1.5 or 12 Mbps is
supported.
Protective Earthing
Protective Earthing
The low resistance protective earthing connection is
established via the ground bolt, which is located at the rear of
the housing.
Cable Set for connecting the Control Panel
Cable Set
C9900-K510 Kit for connecting CP68xx, containing:
DVI-cable 3 m, USB-cable 3 m and power supply connector
6 CP68xx