BECKHOFF CU8005-0000 - Manual (Page 13)

Installation
CU8005-0000 11
3.3 Connecting devices
The power supply plug must be withdrawn
Attention
Please read the documentation for the external devices prior to connecting them!
During thunderstorms, plug connector must neither be inserted nor removed!
When disconnecting a plug connector, always handle it at the plug. Do not pull the
cable!
3.3.1 Connecting cables
The connections are documented in the section Product Description .
When connecting the cables to the CU8005-0000, proceed according to the following sequence:
 Switch off all the devices that are to be connected
 Disconnect all the devices that are to be connected from the power supply
 Connect all the cables between the CU8005-0000 and the devices that are to be connected
 Reconnect all devices to the power supply.
3.3.1.1 Mounting power supply connector
The connector for the power supply has a clamp. It will be installed with a screwdriver:
1. Insert screwdriver into the left hole
2. Plug bared cable into right hole
3. Remove screwdriver
4. The Cable is installed.
2. 1. 3. 4.