BECKHOFF C9900-U332-0010 - Manual (Page 11)

Installation
3.2.2 Horizontal Installation
After modification of the mounting plate (see also chapter Modification of the mounting plate ) the battery
pack can be installed in horizontale position on the top hat rail.
Battery pack
C9900-U332-0010,
horizontal installation
2
1
3
The electrical connections (1) are located at the front of the unit.
The rear of the battery pack is installed on a top hat rail (2) of type TS 35 x 15 in the control cabinet. The
battery pack is fixed on the rail from the front side with the four allen screws (3), using an allen wrench
size 3.0.
3.2.3 Modification of the mounting plate
After modification of the mounting plate the battery pack can be installed in horizontal position on the top
hat rail. Procceed as follows:
Rear view,
vertical orientation
on delivery
2
2
1
1. Remove the sheet for the ground connection (1), using an allen wrench size 3.0.
2. Remove the two mounting notches (2), using an allen wrench size 2.5.
3. Rotate the battery pack about 90 degrees as shown on the following picture.
C9900-U332-0010 9