BECKHOFF CP77xx - Manual (Page 19)

Appendix
CP77xx 17
Appendix
Technical data
Dimensions Dimensions (W x H x D): see section Assembly dimensions
Operation in areas that are
subject to explosion hazard The Panel PC must not be used where there is a risk of explosion.
The following conditions must be observed during operation:
Environmental conditions Ambient temperature: 0 to 55°C
Atmospheric humidity: Maximum 95%, non-condensing
Shock resistance Sinusoidal vibration:
(EN 60068-2-6) 10 to 58 Hz: 0.035 mm
58 to 500 Hz: 0.5 G (~ 5 m/ s 2 )
Impact:
(EN 60068-2-27/ 29)
5 G (~ 50 m/ s²), duration: 30 ms
Protection class Panel PC: IP65
Ethernet Connector: IP65
Power supply Supply voltage: 24 V
DC
(20.4 – 28.8 V
DC
)
Power consumption: approx. 18 W with 6.5“ display
approx. 22 W with 12“ display
approx. 33 W with 15“ display
approx. 40 W with 19“ display
EMC compatibility Resistance to interference: conforms to EN 61000-6-2
Emission of interference: conforms to EN 61000-6-4
Transport and storage The same values for atmospheric humidity and shock resistance are to be
observed during transport and storage as in operation. Suitable packaging
of the Panel PC can improve the resistance to impact during transport. The
ambient temperature during storage and transport must be between -20°C
and +65°C.
i
Note
Pixel errors in the TFT display are production-caused and represent
no complaint-reason!
Approvals
FCC: Federal Communications Commission
Radio Frequency Interference Statement
FCC Approval for USA This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at his own
expense.
FCC: Canadian Notice
FCC Approval for Canada This equipment does not exceed the Class A limits for radiated emissions
as described in the Radio Interference Regulations of the Canadian
Department of Communications.