BECKHOFF CP72xx - Manual (Page 13)

Installation Instructions
Installation of the Panel PC
The Panel PC series CP72xx is designed for mounting arm installation. A
Control Panel is installed in the front of the IP65 Panel PC.
The ambient conditions specified for operation must be observed (see the
section
Technical data ).
Circulation of air
Note
When the unit is installed in an enclosure, adequate space for ventilation
and for opening the PC must be provided.
Please note the following points during installation of the PC:
• Position the PC in such a way that reflections on the screen are
avoided as far as possible.
• Use the position of the screen as a guide for the correct installation
height; it should be optimally visible for the user at all times.
• The PC should not be exposed to direct sunlight.
Avoid extreme environmental conditions
Attention
Extreme environmental conditions should be avoided as far as possible.
Protect the rear of your PC from dust, humidity and heat.
The clearance above and below the housing must be at least 20 cm in
order to ensure adequate ventilation of the PC.
The cooling ribs of the PC must not be covered.
Mounting arm installation
Rotatable mounting arm
adapter The industrial PC is designed for mounting arm installation using a 48 mm
diameter mounting arm tube. The case features an integrated rotatable
mounting arm adapter.
Rotatable and tiltable
mounting arm adapter
(optional) The swivelling range of the tiltable
mounting arm adapter (optional) amounts
to approx. 45°.
~45°
CP72xx 11