Signal, Connector description, Serial interface – BECKHOFF CP67xx User Manual
Page 8: Power supply, Network interfaces, Usb interfaces, Protective earthing
Product Description
Pin
Signal
Pin
Signal
1
5V
3
D+
2
D-
4
GND
X 104 USB1, USB2
USB ports
USB Type-A twin circuit board mounting
(FCI 72309-0030B USB Double Receptacle
A-Type)
Connector description
Serial interface
Serial interface
COM1
The Built-in Panel PC is equipped with a COM1 (X 100) serial interface
(Type RS232) for the connection of serial peripheral devices.
Power supply
Power supply
The power supply for the Built-in Panel PC is established via the Cage
clamp socket (X 101).
A power supply connector is provided with the Built-in Panel PC.
Network interfaces
Network
The RJ-45 sockets (X 102, X 103) enable connection of the Built-in Panel
PC to an Ethernet network.
USB interfaces
USB1 – USB2
The two USB2.0 interfaces (X 104, connector type A) are used for
connecting peripheral devices with USB connection.
Protective Earthing
Protective Earthing
The low resistance protective earthing connection is
established via the ground bolt, which is located at the rear of
the housing.
6
CP67xx