BECKHOFF C33xx - Manual (Page 11)

Product Description
Interfaces up to C33xx-0040
ATX motherboard
interfaces
PS/2-connectors
PS/2 The lower PS/2 connector (2) allows a keyboard to be used, while a PS/2
mouse can be connected to the upper PS/2 connector (1). If the PC is
fitted with an optional Touch Pad this PS/2 connection is occupied.
Parallel interface
Printer
LPT1 The parallel interface (3) corresponds to the Centronics standard, and is
addressed by the software as LPT1.
Serial interfaces
RS 232
COM1 – COM2
The basic version of the Industrial PC has two serial interfaces, COM1 (4)
and COM2, using the type RS 232, which are each brought to a 9 pin
SUB-D plug connector. The interface COM2 is located in the first slot right
below the ATX-slot.
One of the two serial interfaces is used for connecting the special keys and
the LEDs on the front side. If the PC is fitted with Touch Screen (optional),
the second serial interface is occupied too.
VGA connection
VGA A 15-pin SUB-D socket connector (5) allows a VGA monitor to be
connected.
USB interfaces
USB1 – USB4 The four USB interfaces (6 – 9) are used to connect peripheral devices
with USB connections.
Network connection
Network The RJ-45 connector (10) allows the PC to be connected to a Local Area
Network (LAN).
Sound-On-Board
Sound The Industrial PC has a on-board-interface with the following connectors:
Line In jack (11), Line Out jack (12) and Microphone jack (13).
Additional plug-in cards (optional)
Type plate A type plate is located on the upper side of the PC, providing information
about the Industrial PC equipment as delivered.
3 10
11
1
12
4 5
6 8
2
13
7 9
C33xx 9