Baumatic BHG900.5SS - Manual (Page 28)

If it becomes necessary to replace a gas tap, then you should proceed
as follows:
o
Remove the control knobs, pan supports, burners, hob fixing
screws and clamps.
o
Remove the hob from the worktop and remove any underside
protective covers.
o
Disconnect the fixings holding the tap to the fascia panel and
separate the assembly.
o
Disconnect the gas pipe from the gas tap, and then
disassemble them from the gas rail by removing the fixing
screws.
o
When fitting a new tap, ensure that a new gasket is used.
o
Reconnect the gas tap, perform a gas soundness test and
then reassemble the hob.
Electrical connection
This appliance must be installed by a qualified
person in accordance with the latest edition of the
I.E.E. Regulations and in compliance with the
manufacturer’s instructions.
Before connecting the appliance, make sure that the supply voltage
marked on the rating plate corresponds with your mains supply
voltage.
o
Cable type: H05 RRF 3 core x 1.5 mm³ (Type RR-F
marked).
o
The mains supply cable is supplied with this product.
28