Connecting the vk-p6se to your system, Description of controls – Balanced Audio VK-P6SE Phonostage User Manual
Page 7
Connecting the VK-P6SE to Your System
Cartridge Input
The back panel of the VK-P6SE phono stage is equipped with one set of RCA
cartridge input connectors.
Output Connection
The VK-P6SE is equipped with XLR output connectors. Any high quality set of
balanced interconnects can be used to connect the VK-P6SE to your balanced
preamplifier.
Single-ended preamplifiers can be connected to the VK-P6SE output
through the use of XLR-to-RCA adapters, available from BAT.
Description of Controls
Power Switch
The power switch toggles between two positions: OFF and ON. Turning the
unit OFF (even for a short period of time) will reset the soft start and mute
circuits. The VK-P6SE will then require about 45 seconds to return back to
normal operation.
When you turn the unit ON, the VK-P6SE will automatically go through a
gentle power-on sequence. At the end of this sequence the unit will
automatically unmute. However, since the source volume may be unknown at
this time, it is advisable to turn the volume control on your preamplifier fully
counterclockwise and place the mute switch in "Mute" position before
turning the VK-P6SE ON.
Output Muting