Baja Motorsports DR70 Assembly Guide - Manual (Page 8)

8 — English © 2010 Baja, Inc. All Rights Reserved.
ASSEMBLY
INSTALLING FRONT WHEEL
 Remove plastic plug from brake calipers.
 Place the front wheel in the correct position between the
steering forks.
 Starting from the right side (opposite the chain) of the dirt
bike, slide the axle bolt through the fork, wheel spacer,
wheel with brake hub, and other side of fork.
 Install the nut and tighten securely. Torque to 26-33 ft.lbs.
(35-45 Nm).
WARNING:
Strictly adhere to all torque wrench tightening specifica-
tions. Failure to do so could cause serious personal injury.
 Check the air pressure of the tires and inflate as needed
to the proper amount.
NOTE: Tire pressure should only be measured or
adjusted when tires are cold.
Recommended Pressure
15-18 psi (103-124 kPa)
WARNING:
Check the tire pressure carefully while inflating. Too much
air in the tire could cause the tire to burst, causing serious
personal injury.
INSTALLING SIDE PANELS
 Remove the two seat screws as shown. Remove seat and
set aside.
 Install side panel as shown. Insert top panel screw and
tighten securely.
 Repeat on opposite side to install other side panel.
 Reinstall seat. Reinstall seat screws and tighten securely.
WARNING:
Make sure seat is in proper position and attached securely
when you install it. Failing to install the seat properly could
allow the seat to move and cause the rider to lose control,
resulting in possible serious personal injuries.
 Install bottom panel screws on both sides and tighten
securely.
PLASTIC
PLUG
PLASTIC
PLUG
WARNING:
Maintaining correct air pressure in the tires is very impor-
tant. Too little pressure could allow the tire to rotate off
the wheel rim. Too much pressure could cause the tire to
burst. Failure to maintain correct air pressure in the tires
could cause problems with vehicle operation and stability,
causing serious personal injury.
NUT
WHEEL
SPACER
SEAT
SCREWS
TOP
PANEL
SCREW
BOTTOM
PANEL
SCREWS
AXLE
BOLT