Baja Motorsports CN90-U Assembly Guide - Manual (Page 6)

Install battery under seat
Battery Installation
Preparing the battery:
· Place battery on level surface. Remove Vent cap from battery vent located
on top side portion of battery. (see figure 20)
· Remove cell caps using a pair of pliers. (see figure 21)
· Wear eye protection and rubber gloves for this step. Cut off tip of
electrolyte bottle and attach tube. Place other end of tube in battery and
allow the electrolyte to drain in battery cell. Fill battery to upper level mark
located on front of battery. Repeat step for each of the 6 cells (see figure
22)
· After each cell is filled with electrolyte to upper level, remove tube from
battery and set electrolyte aside.
· Discard empty electrolyte bottles in a waste area that is inaccessible to
children and animals.
· After filling let battery stand for at least 30 minutes before charging. This
allows the electrolyte to penetrate plates for optimum performance and
ensures longer battery life.
· After 30 minutes the battery is ready for its initial charge. Place caps loosely
over cell holes.
Figure 20
Vent
Figure 21
Figure 22
How to Initially Charge the battery:
1. Connect the red positive (+) cable to the red positive (+) pole of the battery.
(see figure 24)
2. Connect the black negative (-) cable to the black negative (-) pole of the
battery. (see figure 25)
Note: The red positive (+) cable has a larger diameter than the black
negative y cable.
3. Charging rate: Charge battery @ 0.7 Amps for
5 ~ 10 hours.
• After charging is complete, re-install securely all six battery caps (see
figure 26)
• Install battery into battery tray located under seat (see figure 27).
• Once battery is firmly seated in tray, attach red positive (+) wire to positive
(+) terminal on battery, then attach black negative (-) wire to negative (-)
terminal on battery (see figure 28)
Figure 25
Figure 27
Figure 24
Figure 26