BAFO BF-110N - Manual (Page 12)

USB Net- Work Cable User’s Manual 12
After you install this Bridge Driver on Computer B, there will be one more protocol:
USB-USB Networking Bridge in the Network Configuration. This is a routing
protocol; you can use it to bridge between an USB LAN and an Ethernet LAN.
3 3 3 3 6 ! 7 ' 7 ! 6 ! 7 ' 7 ! 6 ! 7 ' 7 ! 6 ! 7 ' 7 !
10.1 When all installation processes are completed, you have to specify an IP
address, Subnet Mask and Gateway on Computer A:
10.2 Click the Start menu, point to Setting\Control Panel . Double click Network
icon. In Configuration tab, select TCP/IP -> USB-USB Network Bridge
Adapter , and then click Properties .
10.3 In IP Address tab, please choose “ Specify an IP Address ”, and fill in the IP
address and Subnet Mask value properly. This information should be from
your MIS people and make sure this IP Address , which is not in use of your
Ethernet , or it will cause a network failure.
10.4 In Gateway tab, you must specify a proper value. This IP Address of Gateway
should be the same with the other Computers in the Ethernet.