Dixon 6601 Series - Manual (Page 11)

SPECIFICATIONS
Model ZTR 6601
CHASSIS: 1 1 GA - rectangular tube
BODY: Two piece - made of rotational molded polyethylene. Front body contains
access panels for battery service and engine to mower deck belt removal. Rear
body tilts up to allow service on the entire drive system.
SEAT: Economically designed for operator comfort by use of high density closed cell
foam, contoured back rest and arm rests. Seat is adjustable fore and aft.
MOWER DECK: 1 0 GA stamped steel construction 3 blades combine for 60"
cut width Cut height approximately 1" to 4.5" via 8 position lift
handle
BLADE DRIVE: Electric clutch
DRIVE SYSTEM: Each rear wheel is independently driven by a HydroGear BDU-10L Series 70
hydrostatic transmission. The hydrostatic transmissions, in turn, power a fully
enclosed HydroGear gearbox.
ENGINE: 22 HP Kohler Command, 4-Cycle, Twin Cylinder, V-Configuration, Overhead
Valve, Air-Cooled, Gasoline, Vertical Shaft, Aluminum Head and Crankcase with
Cast Iron Liners, Oil Cooler.
STARTING SYSTEM: Electric by key switch operation with safety interlocks on parking brake and blade
drive clutch.
TIRES: Front 1 1 X 4 X 5 Ribbed Tread
Rear 20 X 1 1 X 8 Turf Tamer AT.
RECOMMENDED
TIRE PRESSURE:
Front 16-21lbs. Rear 5
Ibs. maximum pressure
CAPACITIES: Fuel - 4.8 gallons total (dual tanks) Hydrostat oil tank -
3 quart with in-line 10 micron filter Hydrostat oil
recommendation, refer to page 29 Engine - 2 qts. SAE
1 0W30 (with filter)
DIMENSIONS: Width 72"
Height 45"
Length 89"
Weight 700 Ibs.
NOTE: Additional information provided in service instructions underthe individual
component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
Page 8