AVocation Systems SR-2 User Manual
Sr-2 instructions, Sr-2

SR-2 Instructions
+12vdc
Gnd
Master Port
Port A
Port B
The SR-2 allows two control systems to have access and control of a product with a single RS-232 port. Communications
through Port A or Port B will be sent to the Master Port. When the product responds through the Master Port the
communications will be sent to both Port A and Port B. Please note that the SR-2 only has RX, TX and Ground signals
and is capable of transmissions speeds up to 460800 baud.
10956 Ammons St.
Westminster, CO 80021
Ph: 303-410-6639 l 1-877-805-6639
www.avocationsystems.com
Controller
A
Controller
B
Product to
Control
SR-2
Port A
RX=3
TX=2
Gnd=5
Port B
RX=3
TX=2
Gnd=5
Master Port
RX=2
TX=3
Gnd=5
The following diagram shows the connector pins used for each of the SR-2 connections.
A typical installation will use a modem cable (straight through connections) between the controller and
the SR-2. The SR-2 Master Port is designed to connect directly into a modem port on a product to be
controlled.
In the case where you need to control an Avocation Systems A/V Routing product the master port will
need a null-modem adapter between the Master Port and the Avocation product.