Avionics Innovations DVD/AM/FM Receiver & 8-Disk CD Changer P/N: AV2006 Operation Manual - Manual (Page 8)

Avionics Innovations
AI Shuttle Operation and Installation Manual
Revision NC 03 Mar 1998
Page 8
Notes
••
The titles will remain in memory unless battery power is disconnected.
••
When the CD Shuttle power supply is disconnected the memory for the entered titles is
cleared.
••
When the memory capacity is used up, “FULL DATA” will be shown in the display. At this
point no titles can be programmed unless others are selectively erased.
Erasing Disc Tittle
1. Press the TITLE button to select the disc-titling mode. Then, press and hold this same button
for at least 3 seconds.
2. Press and the PLAY/PAUSE button for at least 3 seconds to activate the title-erasing mode.
The title in the display will blink.
3. Press the s or t button repeatedly until the disc title you want to erase is displayed.
4. Press and hold the PLAY/PAUSE button for at least 3 seconds to erase the disc title
displayed.
5. Press and hold the TITLE button for at least 3 seconds to cancel the disc title-erasing mode.
Battery Replacement
Applicable battery: Use one
CR2025 or equivalent.
Opening the battery case
1. Place the remote upside down on a flat, level surface.
Looking at the back of the remote, grasp the battery at
the bottom of the unit between your forefinger and
thumb. Insert a pointed object into the left side of the
elongated hole. Slide the pointed object to the right (as
indicated by the arrow) while at the same time pulling on
the battery holder.
2. Pull the battery holder out with your thumb and
forefinger.
Replacing the battery
Put the battery in the case with the (+) indication upward as
shown in the illustration.
Then push the battery holder back into the remote until a
click is heard.