Installation instructions, Note, Post installation checkout – Avionics Innovations SSR (Panel Mounted Sirius Satellite Receiver) P/N: SSR019 Installation Manual User Manual
Page 7
Avionics Innovations
AI-SSR Installation Manual
INSTALLATION INSTRUCTIONS
NOTE
FOR TECHNICAL ASSISTANCE PLEASE CALL 760-788-2602 8:00 AM TO 5:00 PM PST.
ALL REPAIRS AND RETURNS ARE PROCESSED THROUGH AVIONICS INNOVATIONS
NOTE
This unit requires a subscription service from Sirius Satellite Radio. The service can be obtained by
contacting Sirius Satellite Radio @ 1-888-539-7474 or on the web
needed to start subscription will be aircraft make and model, owners address, credit card
information for monthly billing and the Sirius ID # located on the back panel of the AI-SSR unit.
1.
Select an appropriate location in the instrument panel for the AI-SSR tray.
A. Location should be as near to center to maximize viewing quality.
2. Mount tray in location using (6) 6/32 countersunk screws. Screws must mount flush to the
inside of the tray for clearence.
3. Wire the unit as per attached diagram.
4. Install antenna on top of aircraft using approved practices and
data. Ensure the antenna is well bonded Resistance between antenna and mating surface to be
less than 10m
Ω.
5. Use RG 142 for antenna lead.
INSTALLATION NOTES:
1. The Antenna will need a clear view of the Northern Sky for proper reception. The AI-SSR will not
operate inside the hangar, and in some instances next to tall hangars that ubstruct the view of the
Satellite to the Antenna
2. Consult the intercom manufacturer for specifications and hookup instructions.
3. Unit must be completely seated in tray to ensure proper connection.
4. Do not over tighten the unit into the tray. Over tightening can damage unit.
POST INSTALLATION CHECKOUT
1.
Ensure unit operates according to the AI-SSR operations manual 9000A
Revision NC 11/27/2002
Page 6