Avalon Firestyles 864 TRV GS2 Installation - Manual (Page 64)

64 Optional Equipment
(for qualified installers only)
Travis Industries 4140611 100-01385
GS2 Remote Installation
Packing List
 Transmitter
 Battery Box
 Remote Wall Mount with Attachment
Screws and Anchors
 Stepper Motor
 Torx Wrench
 Remote Control DVD
 GSR2 IFC
 Splitflow Harness (attached to IFC)
 System Jumper (attached to IFC)
 Battery Box Harness (attached to IFC)
 Fan/Light Harness (attached to IFC)
 (2) Jumper Wires
 (2) 4” Cable Ties
Warnings
Turn off power to the heater (unplug or turn off at the breaker).
Shut off gas at the appliance (or at meter).
HINT:
If using a blower, make sure to have it on hand while installing the remote.
Remote Control / Pilot Warnings
Installing batteries in the battery holder or connecting the appliance to power may automatically
initiate the CPI pilot mode, resulting in a lit pilot flame. Do not place combustibles in the firebox.
KEEP BATTERIES AND COVER
INSTALLED AT ALL TIMES
The remote control system requires the batteries and battery cover to remain in place at
all times. Once the batteries or cover are removed, the system may re-start in standing
pilot mode. If this occurs when the heater is in Remote Mode, you will not be able to turn
the heater off manually from the battery box.
If you need to replace dead batteries, make sure to turn the appliance off before
removing the batteries.
NOTE: If the batteries go dead, the system will operate normally as long as household
power (120v AC) is present.