Specifications – Dixon ZTR 7025 User Manual
Page 11
Page 11
CHASSIS:
11 GA - rectangular tube
BODY:
Folded sheet metal.
SEAT:
Designed for operator comfort with padded back and arm rests. Seat is adjustable
fore and aft.
MOWER DECK:
2 Decks are available. Both decks are made of 10 GA fabricated welded
construction with 7 GA reinforcement plate. 3 blades combine for either a 52" or
60" cut width. Cut height approximately 1.5" to 5" via 7 position lift handle.
BLADE DRIVE:
Electric clutch
DRIVE SYSTEM:
Each rear wheel is independently driven by a HydroGear BDU-10L Series 70
hydrostatic transmission. The hydrostatic transmissions, in turn, power a fully
enclosed HydroGear gearbox.
ENGINE:
25HP Kohler Command, 4-Cycle, V-Configuration, Overhead Valve, Air-
Cooled, Gasoline, Vertical Shaft, Aluminum Head, and Crankcase with Cast
Iron Liners, Full Pressure Lubrication/Full Flow Filter, Pulse-type Fuel Pump,
Fixed Jet Carburetor w/Smart-Choke, Electronic Ignition, In-Line Fuel Filter,
Dual Element Air Cleaner.
STARTING SYSTEM:
Electric by key switch operation with safety interlocks on parking brake and
blade drive clutch.
TIRES:
Front
13-5.00x6
Rear
23-9.50x12
RECOMMENDED
Front
12 lbs.
TIRE PRESSURE:
Rear
12 lbs.
CAPACITIES:
Fuel - 11 gallons (approx)
Hydrostat oil tank - 3 quart with in-line 40 micron filter
Hydrostat oil recommendation, refer to page 36
Engine - 2 qts. SAE 10W30 (with filter)
DIMENSIONS:
Width
61"(52" Deck), 69-1/2"(60" Deck)
Height
43"
Length
81" (52” Deck), 81” (60” Deck)
Weight
915 lbs.(48" Deck), 916 lbs.(60" Deck)
NOTE:
Additional information provided in service instructions under the individual
component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
SPECIFICATIONS
7000 Series