Audio Enhancement First Time - Manual (Page 3)

DC-40437.01
3 www.AudioEnhancement.com • 800.383.9362
5 Playing sound from external devices
There are two methods of connecting a multimedia device such as a phone, tablet, MP3 player, or
computer to an Audio Enhancement system. They may be connected to an input on the back of the
amplifier or to the AUDIO IN port of either the Teardrop or Handheld infrared (IR) microphone.
The Ultimate III uses both RCA audio line inputs (Line 1) and 3.5 mm audio line inputs (Lines 2 and 3).
The auxiliary input on the microphones uses a 3.5 mm input.
Step 1:
Step 1:
Step 3:
Step 3:
Step 2:
Step 2:
Obtain a standard audio cable that has a 3.5 mm stereo plug on
both ends.
Obtain a standard audio cable that has a 3.5 mm stereo plug on
one end and two RCA male connectors on the other end.
The volume control on the MP3 player or computer can be used to set the playback
level. The arrows on the microphone can also be used to control the volume when the
microphone is set to LINE.
Connect the 3.5 mm plug to your multimedia device. There will
be a corresponding knob on the front to control the volume
through the amplifier/receiver. The arrows on the microphone
can also be used to control the volume when the microphone is
set to LINE.
Connect one end of the cable to the AUDIO IN port on the
microphone or amplifier and the other end to the headphone
output of the MP3 player or computer.
Connect the two RCA male connectors to the back of the
amplifier. Plug the white connector into the white port of Line 1,
and the red connector into the red port of Line 1.
Volume control for playback
Audio IN port
3.5 mm audio input
RCA audio input