ATI Audio HDA600 User Manual
Page 4

Audio Technologies Inc. | 154 Cooper Road #902 | West Berlin, NJ 08091 | Voice 856-719-9900 | Fax 856-719-9903 | www.
audio.com
PERFORMANCE SPECIFICATIONS
OUTPUTS:
Six high compliance 6V/80mA stereo drivers capable of over
100mW into six 32 to 600 ohm stereo headphones
DYNAMIC RANGE:
110dB Typical at output into 600-ohm headphones
DISTORTION:
.10% THD max, .01% type, 20-20000 Hz, any level below
clipping
RESPONSE:
+0/-.5dB, 20-20000 Hz
GAIN:
Program Inputs 26dB.
Cue Input 65db Mic, 35 or 25dB line,
Direct Input 10dB.
NOISE:
Program Input -90dBu E.I.N., 20 – 20000 Hz Cue Mic Input -
110dBu E.I.N.
Direct Inputs –90dBu E.I.N.
SEPARATION:
70dB minimum at 1kHz
INPUTS:
Program: Stereo, 20K balanced, bridging, -10 or +4dBu
nominal Cue: Mono, 2Kohm balanced, diode protected, -50,
and -10, 0dBu nom. Direct: Stereo 10K unbalanced or Mono
20K balanced, 0dBu nominal
PHANTOM PWR:
+12VDC available for Cue Microphone, selected with P3 and
S2 in MIC position, Resource = 600 ohms
INDICATORS:
INPUT CLIP - onset of input stage clipping, Yellow LED
CUE CLIP – onset of cue input clipping, Yellow LED
SIGNAL PRESENT– lights 20dB below nominal input level.
Six Green LEDs
POWER – monitors internal DC voltage - Red LED
POWER:
115/230VAC +/- 10%, 50/60Hz, 24VA, and IEC320 3 pin
connector
SIZE: 1RU
package;
19”(48.3cm) W x 1 ¾”(4.5cm) H x
7.5”(19.05cm) D 15lbs (6Kg)