ATI Audio BBU100 - Manual (Page 3)

BBU100 IB21093 Page 3 of 3
PARTS LIST:
1 ea. BBU 100 Battery Pack
4 ea. 9VDC Alkaline or Lithium batteries (not included)
4 ea. 4-40 x 3/16 pan head screws
4 ea. # 4 lock washers
NOTE: This assembly mounts directly to the underside of the mixer.
INSTRUCTION:
1. Insert 4 ea. 9 VDC batteries into the mounting clips on the interior of the BBU 100.
2. Remove 4 ea. rubber feet that attached to the base of the mixer.
3. Position the BBU 100 to the underside of the mixer; make certain that the 24VDC
OUT cable is orientated towards the rear of the mixer.
4. Secure the BBU 100 with 4 ea, 4-40 x 3/16 screws and # 4 lock washers to the mixer.
5. Insert the 24VDC OUT cable located at the rear of the BBU 100 to the 24 VDC IN
receptacle located in the rear of the mixer.