April Music Aura note V2 - Manual (Page 14)

13
This function lets the pre-selected source come on every day at the same time, like
an alarm clock.
“|◀”, “▶|” buttons are used for choosing menu in “TIMER” setting
mode.
(1) To set the TIMER mode, press "TIMER" button once and choose "TIMER ON" or
"TIMER OFF". Then
press "TIMER” button again.
(2) Select source mode for TIMER
and press "TIMER” again.
(3) Set the time. At first set the hour and then p ress "TIMER” button to change to
minute display. Set minutes and press "TIMER" again.
(4) Set the wanted volume level and press "TIMER" again.
(5) Set the automatic system off time from 10 to 240 minutes. Pressing "TIMER"
again will finish the timer setting.
※ Timer setting lasts at STANDBY mode. The setting will be erased if you turn off
MAIN POWER switch.
13) ST/MONO :
This function can improve the sound of a station at the fringe of your reception area
or one suffering from multipath noise (signals bouncing off buildings etc). Often,
putting a noisy station in MONO will reduce the noise and make the sound more
enjoyable.
14) A-B (A-B Repeat) :
This function is useful if you want to listen repeatedly to an interval of music. Press
"A-B Repeat" once to establish your starting point during playback, and press it
again to establish your end point.
15) VOLUME :
Volume buttons control the sound level. Short presses result in volume changes in
small steps from MIN to MAX. Hold down either UP or DOWN button to make the
sound level change continuously.
MIN, 1, 2 ~ 98, 99, MAX (MIN = no output, while MAX = maximum output)
3. Clock Setting
To program the correct time, press "PROG (MEMO/CLOCK)” button. The hour indicators will
blink for five seconds. Use “|◀”, “▶|” buttons to adjust the hour. Press "PROG
(MEMO/CLOCK)" again to set minutes. After you have set the time, the display will stop
blinking after 5 seconds. To reset the clock, put Aura note V2 in STANDBY mode and repeat
the procedure.