AMETEK XBT Series Installation - Manual (Page 2)

Technical Note
XBT Rackmount Installation
Document No. M370187-05 Rev A • 7/3/2008
Figure 3. Unit, Bottom Up, with Main Rackmount Piece Aligned
5. Use screwdriver to secure rackmount piece to unit with two (2) M3.0 screws.
6. If installing two supplies, repeat Steps 1-6, then skip to Step 12. For a single unit, continue with Step 8.
7. Turn assembled unit and rackmount piece so that unit’s top is face up and rackmount piece is lying on work
surface ( Figure 4 ).
Figure 4. Unit, Top Up, Secured to Main Rackmount Piece
8. Set filler panel ( Figure 5 ) in blank space next to unit, flush with side and front lip of rackmount piece ( Figure 6 ).
©2008 Programmable Division of Xantrex Technology Inc. • All rights reserved. • Xantrex is a trademark of Xantrex International, registered in the U.S. and other countries.
9250 Brown Deer Road, San Diego CA 92121 • Tel: 858-450-0085 • Fax: 858-458-0267 • email:
[email protected] • Web: www.programmablepower.com
2 of 6