Optional interface connector accessories, Lan connector, Lan connector pinout – AMETEK ReFlex Mating Connnectors for Controller User Manual
Page 3
Technical Note
ReFlex Power™ Mating Connectors for Controller Module
Document No. W380269-01 Rev F •
1/26/2009
©2008 AMETEK Programmable Power, Inc. • All rights reserved. • AMETEK is a trademark of AMETEK, Inc.
9250 Brown Deer Road, San Diego CA 92121 • Tel: 858-450-0085 • Fax: 858-458-0267 • email:
• Web:
www.programmablepower.com
3 of 3
Signal Types:
A. Bi-Directional Digital I/O. Signals internally pulled up to +5V DC. Externally to be pulled low, (< = 0.5 VDC) relative to the designated signal
return, (signal type C).
B. Internal relay contact that is connected to the return when asserted. Absolute maximum rating 2A @ 30 VDC, 0.5A @ 125 VAC. Minimum
10 mA DC or 10
μA AC current required.
C. Return for type A see above.
D. Connected to the metal enclosure of the module. The enclosure of the module is connected to the earth ground connection of the ReFlex Power™
power input.
E. Externally to be pulled up to +5V to +15V DC, relative to Return Type F. Limit sink current to ≤ 40 mA.
F. Return for Type E, Common mode range ≤ 60 Volts.
OPTIONAL INTERFACE CONNECTOR ACCESSORIES
•
AMETEK P/N 5380509-01, 15-pin Loop-back Connector Assembly. Includes a jumper wire between Pins 1 and 9 to enable
the outputs on all AC/DC/Load modules in a system.
•
AMETEK P/N 5380441-01, Controller Module, 9-ft. Unterminated Cable Assembly. Use when interfacing to an external
system.
•
AMETEK P/N 5380441-03, Controller Module, Right Angle, 9-ft. Unterminated Cable Assembly. Use when interfacing to an
external system.
LAN CONNECTOR
Primary user interface to the ReFlex Power™ system via Ethernet connection
Type: RJ45, CAT 5 compatible
Protocol conforms to IEEE 802.3 Ethernet-based LANs
Mating connector: Amphenol Socapex P/N RJF6MN, AMETEK P/N 856-993-07
Wire size: Standard CAT 5e 10/100-Base-T cable
Maximum length: 10 meters (can be extended subject to the environment and cable type).
LAN CONNECTOR PINOUT
Pin
Name Function Signal
Level
1
TX+
Transmit data positive, twisted differential pair with TX-
IEEE 802.3
2
TX-
Transmit data negative, twisted differential pair with TX+
IEEE 802.3
3
RX+
Receive data positive, twisted differential pair with RX-
IEEE 802.3
4 NA
N/A
5 NA
N/A
6
RX-
Receive data negative, twisted differential pair with RX+
IEEE 802.3
7 NA
N/A
8 NA
N/A