Set up the wi-fi clock, Verify clock hand placement, Hang your clocks – American Time Wi-Fi Analog Clock User Manual
Page 2
If clock was not preconfigured at American Time as recommended, please reference the
Installation & Operation Manual.
5
4
Set up the Wi-Fi clock
1.
Apply power to the clock by inserting the barrel plug
(B)
of the battery pack into the left
side of the Wi-Fi module where the power connection is located.
• Verify the LED
(C)
:
–Flashes red when power is applied to the clock
–Flashes green within 60 seconds
–Green flashing stops within 120 seconds
• Verify the clock hands begin to spin rapidly within six minutes after applying power.
• Verify the correct time on the clock within 20 minutes of applying power.
If any of these steps do not occur, reference the Wi-Fi Clock Installation & Operation Manual.
Verify clock hand placement
1.
Verify the clock hands are set at 12:00 by the factory (if not, stop and call 800-328-8996)
Note: It is normal for the minute hand to shift ±
1
⁄
2
minute.
2.
Remove the green gear locking pin
(A)
from the movement.
Hang your clocks
1.
Place the clock on the wall using the keyhole hanger on the back of the clock or the
optional security bracket (sold separately)..
6
B
Battery
pack power
input
C
LED
A
Green gear
locking pin
Security
Bracket
Keyhole
Hanger
INST-WIFI-ANA Rev 2