American Time CDMA 5 Watt Standard - Manual (Page 2)

QUICK START INSTALLATION GUIDE SITESYNC IQ
®
WIRELESS CLOCK SYSTEM
Connect cables to the system controller
A. Connect the CDMA antenna to the CDMA ANT port.
B. Connect the System Controller power supply to the POWER
INPUT port.
C. Connect the magnet mount TX antenna to the TX ANT port.
Plug 110v cord into power source. Turn the POWER SWITCH on
the back of the system controller to the on position.
Note: If your system controller supports more than one time sync
option, refer to the SiteSync IQ Installation & Operation Manual for
detailed instructions.
MON MAR 10 2014
10:38:06 AM USCT
American Time
Status=AUTO CDMA=S
1 4
5
Unpack the box
1. Remove the components and system controller from the box.
Save the packing materials in case you need them later.
Check the components
Your system kit comes with:
• System Controller
• Hinged screw-on CDMA antenna (A)
• Power supply (B)
• Magnetic mount TX antenna with 12' cable (C)
• Installation & Operation Manual
Choose your location
• Choose a location for the system controller that receives good
cellular reception. The easiest way to check reception is to
check signal strength on a cell phone.
Avoid high voltage equipment when choosing a location.
• Choose a location for your magnetic mount TX antenna either
outside or inside at the highest central location in your facility.
The TX antenna must be located at least 4' away from
the system controller and must always point up or down,
never horizontal! The cable length cannot be extended.
2
3
4 ft
minimum
TUE FEB 09 2010
10:38:06 AM USCT
American Time & Signal
Status=AUTO CDMA=Y
CDMA signal
to facility
CDMA Ant
signal in
TX Ant signal
out to clocks
System controller located
high & central
A
C B
To local
power
(110vac)
Use the Setup Wizard
1. Press 1 to start the Setup Wizard (Page 9 in Installation Manual)
2. Create a 4 digit User Lock or enter 0000 to disable this
feature. Press O . Tip: Record this password.
3. Create a 4 digit Service Lock (for advanced features) or enter
0000 to disable this feature. Press O .
Tip: Record this password.
4. Select local time zone by using the <> keys. Press O .
USET=Eastern USCT=Central USMT=Mountain USPT=Pacific
Note: There are 40 options to choose from.
5. Press 8 to select automatic DST (Daylight Saving Time) or
0 to disable DST if your location doesn't observe DST.
Press O
6. Press 1 for 12-hour mode - AM/PM (1:00PM).
Press 2 for 24-hour mode - Military (13:00).
7. To confirm proper set up, press 8 to sync.
• If successful, “CDMA Sync Successful” will display
• If not successful, “CDMA Sync Failed” will display. Re-try
by pressing 8 again.
8. “Setup Wizard Successfully Completed” will display.
The system controller now shows the correct time and date. You
will no longer be prompted on power-up for setup information.
9. Verify the unit is transmitting. TX should display for about
three seconds every 30 seconds (approximately the top and
bottom of every minute) in the bottom right corner of the
screen.
MON MAR 10 2014
10:38:06 AM USCT
American Time
Status=AUTO TX
Set Menu LOCAL
Time Zone Code: 05
99=Custom USCT
<>=Scroll OK=Accept
Note: Screen
will advance
immediately