American Time Wireless Tone Generator - Manual (Page 4)

© American Time
4
Wireless Tone Generator
Contact
Information
Operation
Specifications
Specifications
Physical Specifications
Receiver Specifications
Output Signal Specifications
Rated Output: ................ Adjustable from 0-1.15 volt P-P
Load Impedance: .......... 600 ohms or higher
Controls: ........................ Gain control - Screwdriver adjustment
Inputs: ........................... T1-T4 four dry contact inputs for tone selection. The Audio In input
allows normal background audio to play. Pre-empted by tone selection inputs T1-T4.
• Steady tones and Whoop last for the duration of the
contact input.
• Pulsed tones are 0.4 seconds ON and 0.4 seconds OFF
with a one second break before repeating.
• A two pulse tone repeats every 2.5 seconds for the
duration of contact input.
• A three pulse tone repeats every 3.25 seconds for the
duration of the contact input.
• The Chime sounds once when the contact is closed and
again when the contact is opened.
Dimensions: ...............................10 1 /
4
"h x 12 1 /
2
"w x 4"d
Weight: ........................................4.8 lbs
Voltage Input: .............................120vac, 11 mA
Operating Temperature: .............41˚-131˚F (5˚-55˚C)
Termination: ................................Screw terminals
Frequency: ..................................450-470MHz (factory set)
Paging Format: ...........................POCSAG, narrow band
Data Baud Rate: ..........................512 BPS
Sensitivity: ..................................10uV/M
Channel Spacing: ........................12.5 KHz
Tone Durations: ..........................1-9 seconds and one minute increments (set by the SiteSync
IQ® system controller)
Order Information
Part # H004313