Zektor SoloCAT™ HD - Manual (Page 8)

4
. Bi directional IR
IR Receiver Cable Directions:
Insert the supplied receiver into the
SoloCAT HD™ “IR2 IN”
port and place the IR Receiver Cable, so that you can point to it
easily with your IR remote controller.
IR Blaster Cable Directions:
Plug IR blaster cable plug into
the SoloCAT HD™ “IR OUT”
port, It sits in front of the source receiver
’s IR sensor, which is
normally located on the front-panel.
IR Receiver Cable
GND
+V
Si g
IR Blaster Cable
NC
P+
N-