Televes T.0X Encoder TWIN HDMI/Composite CVBS - COFDM/QAM - Manual (Page 4)

Installation
1. Install all units in the rack and connect them as shown in Figure 1.
Figure 1
2. The audio and video input signals connect to the back of the
modules.
Figure 2
3. If a network is available that provides IP addresses through DHCP,
connect the encoders to the network as shown in Figure 3. If such a
network is not available, then a computer will need to be connected
as shown in Figure 4.
NETWORK
with
DHCP server
Figure 3 - Rack with DHCP server.
4. Power on the units.
Figure 4 - Rack without DHCP server.
5. Connect the programmer to each unit and set a unique number in
the “# ID” field according to the order of installation of the units in
the rack.
- # ID -
0001
- # ID -
0006
Figure 5 - Set a # number different for each unit.
6. Connect the programmer to a unit, usually the first one, and read
the IP address.
Each unit can work as a master controller for the other units. All units
can be configured by connecting to only one.
- NETWORK -
IP ADDRESS
001.001.
005.097
Figure 6 - Read the IP address of one unit.
7. If a network was connected in Step 3 then proceed to step 8. If not,
set the address of you computer as follows:
IP value = 172.20.0.2
netmask = 255.0.0.0
gateway = 172.20.0.3
NOTE: ThedefaultfactoryconfigurationoftheunitshasanIPaddressin
thisrange(itshouldbedifferentforeachunit).Ifaunitwasever
providedanaddressbefore,manuallyorthroughDHCP,thisunique
address may no longer exist. Resetting to IP factory defaults, will
returntheoriginaluniqueprivateaddressthough.
8. In your web browser, enter the IP address from Step 6 as the URL.
A login prompt will appear. By default the parameters are:
Login: encoder
Password: encoder