Saturn ST-HT7266 - Manual (Page 2)

3
GB
CONVECTION HEATER
Dear Buyer!
We congratulate you on having
bought the device under trade name
“Saturn”. We are sure that our devic-
es will become faithful and reliable
assistance in your housekeeping.
Avoid extreme temperature changes.
Rapid temperature change (e.g. when
the unit is moved from freezing tem-
perature to a warm room) may cause
condensation inside the unit and a
malfunction when it is switched on.
In this case leave the unit at room
temperature for at least 1.5 hours
before switching it on.If the unit has
been in transit, leave it indoors for at
least 1.5 hours before starting opera-
tion.
Read all instructions carefully before
using the appliance
Usage Guidance
Please read this guidance carefully before
using the electrical appliance, so that you
can use it correctly.
Please keep well with this guidance.
Brief Introduction of the product:
The convector adopts convecting heating
technology, and has a high heating efficien-
cy, centralized heat and adjustable heating
range. The convector has a reasonable foot
structure not easy to be toppled by acci-
dent.
Assemble before you use:
Please assemble the feet and the body in
the order given in the picture below.
Place the convector on the flat desk or car-
ton.
Insert the 2 position fins of the feet into the
position holes of the body .
Tight the fixed screw to connect body and
feet.
Usage:
1. Please check before you use:
A: The heating wire and electric wire can
not be broken.
B: Please do not use the socket lower than
10A for fear of any accident.
2. Use the convector on the flat place to
avoid being toppled.
3. There are 2 switches for the power set-
ting. “I” is for 400W, “II” is for 600W. You
can get 3 power setting 400W, 600W,
1000W (400W+600W).
4. There is a thermostat knob for adjusting
heating. You can rotate the knob to get
your desired heating level.
5. If you stop using convector, turn off all
the power switch, then put off the plug.
6. If you want to move the convector,
please turn off the switches, then put off
the plug, and hand on the handle on the
back of the convector.
Name of components:
Electric Drawing:
2