Saturn ST-EC1183 Vienna - Manual (Page 3)

4
8. Do not move the appliance when
it is full of liquid or hot foods.
9. Do not touch the appliance when
it is steaming and use oven gloves to
remove the lid, rice bowl and steamer
baskets.
10. Always unplug the appliance
immediately after use, when moving it
or prior to any cleaning or
maintenance.
11. This appliance is not intended
for use by persons (including children)
with reduced physical, sensory or
mental capabilities, or lack of
experience and knowledge, unless
they have been given supervision or
instruction concerning use of the
appliance by a person responsible for
their safety.
12. Children should be supervised
to ensure that they do not play with
the appliance.
Instruction for use
1. Using warm water and
washing up liquid, wash all the
removable parts and the inside of the
water tank, rinse and dry.
2. Place the base unit on a stable
surface, put the turbo ring around the
heating element (the largest side on
the bottom).
3. Pour the fresh water directly into
the water tank up to the maximum
level.
4. Place the base into the baskets
and put the food on the center of
base.
5. Place the baskets on the top of
the juice collector, and put the lid on.
6. Plug in and set the time for
recommended cooking times (see
table of cooking times), the indicator
light on and steam cooking has begun.
7. Check the water level by looking
the exterior water level indicator; if
necessary, add water from the side of
juice collector during cooking.
8. The switch off automatically, timer
rings and the indicator light off.
9. You can reheat the food , carefully
if there is any more water.
10. Remove the lid, place the
basket(s) on the plate.
11. Unplug the appliance, let it cool
completely before cleaning.
Electro-panel operation
1. Put though the power supply,
you can see the display showing the
time as .
(1) Press the ‘PROG’ and ‘0/1’
buttons at the same time, the buzzer
tweets when loosing the buttons.
(2) Increasing 10 minutes or
decreasing 1 minute per each press on
‘+’ button and ‘-’ button accordingly.
(3) Adjust the clock to the current
time, then ending the whole process
by press ‘PROG’ button.
2. Immediate steam mode
(1) Push the ‘0/1’ button under the
clock mode until the display shows
“45”.
(2) Setting the steaming time by
pressing ‘+’ or ‘-’ buttons, increasing
or decreasing 5 minutes each press.
Press any button and stop the setting
procedure.
(3) The buzzer tweets two seconds
without pressing any button after the
steaming time is set. The red indicate
light brightened at the mean time,
that means the start of steaming, and
the clock starts to count the time.
(4) When setting the time as 0, the
electric timer will return to clock mode
automatically. The maximum steam
time is 90 minutes.
(5) When in steaming, you can press
‘+’ or ‘-’ button adjust the steaming
time. Press ‘0/1’ button to stop
steaming and return back to clock
mode.
3. Timing steam mode
(1) Press PROG under the mode of
Clock, there shows the time and PROG
on the display .
(2) Booking the time by pressing ‘+’
and ‘-’ buttons, increasing or
decreasing 10 minutes each time.
(3) Press ‘PROG’ button until the
display shows 45. Then press ‘+’ and
‘-’ to adjust the steaming time.
(4) Press ‘PROG’ button again, the
display shows the time and PROG,
which means entering into the timing
steam mode. When it comes into the
booking time, the buzzer tweets and
the red light lights, and the steamer
starts to steam the food according to
the set time.
(5) If you want to cancel the timing
steam mode, just press the PROG
button, it return back to clock mode.
4. When the steaming is finished, it
comes into the holding mode directly.
The display shows the time and the
holding symbol and the green light
lights .
Holding mode means warming for 2
minutes per 8 minutes after it stops
steaming.
5. Press 0/1 press to cancel the
holding mode, and it returns back to
clock mode.
5
Cleaning and maintenance
1. Empty the water tank and clean it
with a damp cloth.
2. All the other removable parts can
be put in the dishwasher.
3. Descale the appliance every 8
times.
4. Position the turbo ring upside
down around the heating element (the
largest side on the upper). Fill the
water tank with cold water up to
“MAX” level, fill the inside of the turbo
ring with white vinegar to the same
level. Do not heat up (to avoid the
descaling odor). Leave overnight to
descale. Rinse out the inside of water
tank with warm water several times.
5. Stack the baskets one to the
other following No.1 into No.2, then
together into No.3. Put the rice bowl
into the Steamer basket No.1.At last
place the baskets on the juice collector
and put lid over them all.
Warranty information
The warranty only covers defects in
material or workmanship.
The repairs under warranty may only
be carried out by an authorized
service centre. When making a claim
under the warranty, the original bill of
purchase (with purchase date) must
be submitted.
The warranty will not apply in cases
of:
- Normal wear and tear
- Incorrect use, e.g. overloading of
the appliance, use of non-approved
accessories
- Use of force, damage caused by
external influences
- Damage caused by non-observance
of the user manual, e.g. connection to
an unsuitable mains supply or non-
compliance with the installation
instructions
- Partially or completely dismantled
appliances.
Technical Data:
Power: 800 W
Rated Voltage: 220-230 V
Rated Frequency: 50 Hz
Rated Current: 3.6 А
Set
FOOD STEAMER…..…………. ..............1
INSTRUCTION MANUAL WITH
WARRANTY CARD………………………………1
RICE BOWL………………………………………..1
PACKAGE….…………………...................1
ENVIRONMENT FRIENDLY
DISPOSAL
You can help protect the
environment!
Please remember to
respect the local
regulations: hand in the
non-working electrical
equipments to an
appropriate waste
disposal center.
The manufacturer reserves the
right to change the specification
and design of goods.
RU
ПАРОВАРКА
Уважаемый покупатель!
Поздравляем Вас с
приобретением изделия
торговой марки “Saturn”.
Уверены, что наши изделия
будут верными и надежными
помощниками в Вашем
домашнем хозяйстве.
Не подвергайте устройство
резким перепадам температур.
Резкая смена температуры
(например, внесение устройства
с мороза в теплое помещение)
может вызвать конденсацию
влаги внутри устройства и
нарушить его работоспособность
при включении. Устройство
должно отстояться в теплом
помещении не менее 1,5 часов.
Ввод устройства в эксплуатацию
после транспортировки
производить не ранее, чем через
1,5 часа после внесения его в
помещение.
Пожалуйста, строго
придерживайтесь Инструкции по
Эксплуатации!
Это устройство выпускает
горячий пар!
Описание
1. Крышка
2. Контейнер для риса (емкость 1
л) (в зависимости от модели)
3. Овальный контейнер № 3
(в зависимости от модели)