Saturn ST-EK8031 User Manual
Page 3

4
12. This appliance is not intended for
use by persons (including children)
with reduce physical, sensory or
mental
capabilities,
or
lack
of
experience and knowledge, unless
they have been given supervision or
instruction concerning use of the
appliance by a person responsible for
their safety. It is not advised to use
this appliance by children under 14.
Caution
1. Don't allow pins or other metal
objects to contact the appliance plug.
2. Always grasp the power supply plug
when unplugging the power cord.
3. Don’t attempt to pour hot water
while it is boiling or immediately after
it has boiled.
4. Unplug the electrical plug when the
dispenser is not being used for a long
time
5. To avoid burning, don't overlay the
steam vent.
6. When open the lid, don't allow the
steam to contact your skin.
Note:
1. Don't turn on the dispenser when it
is empty.
2. Don't use the dispenser on a
kitchen storage shelf or within 30cm
of a wall or furniture.
3. Don't use the dispenser near a heat
source.
4. Don't fill the dispenser with other
things except water.
How to use
On first usage full fill water and boil
according to the instructions below.
You may notice a smell of plastic the
first time you use the dispenser. This
is normal and will fade over time.
Caution
Do not pour in water above the full
water supply mark (if you do, hot water
will overflow). Do not get bottom of this
pot wet. Always close the lid securely.
Do not plug in, when the inner
container is empty. When you plug in,
the "BOIL" lamp lights up. When the
boiling is completed, the "KEEP WARM"
lamp lights up.
Time required for boiling 26.5 minutes
(about). (Timing different according to
regions)
Caution
Do not open the lid while the water is
being boiled. Be careful of the steam
coming out from the steam vent. Do
not place anything over steam vent.
Pour water with air pump
5
BOILING
Please this pad to reboot water that is
being kept warm.
Time required for reboiling 2~3 minutes,
when water is up to maximum water
supply mark and room temperature is
20
0
C).
Silicon gasket of the upper lid
If the gaskets lose their pliancy, or for
any other reason steam to escape from
between the container and lid, replace
them.
Cleaning & Maintaining
Before cleaning remove the plug.
Exhaust the remaining hot water and let
the pot cool oft before cleaning its,.
Body and lid
Clean the body with a damp, well-
squeezed cloth. Do not use benzene,
paint thinner. Do not wet the body or the
lid or soak them into water. Wipe any
moisture and grime off the lid and gasket.
Inner container
Wash with a sponge.
Do not use scouring powder.
Do not let the water overflow.
If the sponge cleaning can not get inner
container clean:
1) Fill the container with water and the
juice of one or two lemons or citric acid,
boil the water and let the pot hold warm
for about an hour.
2) Rub with a nylon scrub brush and rinse
well. These are reddish slain spots,
caused by the action of substance in the
water is not discoloration or corrosive of
the inner container itself and is not
harmful.
Careful washing prevents grime and
discoloration.
Before calling for Service
What to check
Symptom
Cause
Solution
The water
does
not
boil.
The power
cord
is
unplugged.
Plug it in.
The
hot
water does
not come
or only a
little does.
The power
cord
is
unplugged.
Silicon
gasket
of
the inner lid
gaskets lose
their
pliancy.
Plug it in.
Replace
Item.
Technical Data:
Power:
800 W
Rated Voltage:
220-230 V
Rated Frequency:
50 Hz
Rated Current:
3.63 A
Capacity
3.8 l
Set
Thermos Pot
1
Instruction Manual
1
Warranty Book
1
Package
1