Pengo LDS Series - Manual (Page 6)

SET UP INSTRUCTIONS
5
The PENGO Earth Auger Drive Unit
receives its Hydraulic oil flow and
pressure from the Parent Machine
through the Auxiliary Hydraulic
(Attachment) Circuit via two Quick
Release Couplers normally located
near the end of the Loader arms,
Excavator Dipper or Truck Crane
Booms etc.
Mounting Frames are attached to
the Bucket Attaching Points on
Loader arms and Excavators. On
Truck Cranes a Linkage is normally
located between the Hook Pin and the
PENGO Earth Auger Drive Unit.
FIG 2: Typical mounting for
Excavators.
FIG 3: Typical mounting for Skid
Fig 1
Fig 2
Fig 3
Fig 4
CAUTION: Alert yourself to the weight(s) of the PENGO product(s) Refer Pg 4
You operate. Do not exceed your machine operating weight
or lifting capacity. (Refer to your machine manual)
KG
Ensure your machines Flow & Pressures do not exceed the maximum rated Flow & Pressures
of the PENGO Earth Auger Drive Unit. (Refer Pg 2 To the Purchaser)
(1) Fit Mounting Frame (Refer Above)
(2) Fit PENGO Earth Auger Drive Unit using Bail and Pins.
(3) Hook up hoses to Auxiliary Hydraulic Circuit. ENGINE MUST BE SHUT OFF.
(4) Check that the drilling rotation on PENGO Earth Auger Drive Unit is clockwise.
NOTE: Two-way flow is required for anticlockwise rotation.
(5) To assure optimum Hydraulic Motor life, run new PENGO Earth Auger Drive Unit for one hour
on approx. 1/3 rd RPM before application of full load.
(6) Fit Auger. (See Fig 4) Use only genuine PENGO Auger Pin and Spring Clip.
REMOVAL PROCEDURE: Reversal of Set up Instructions.