Recommended tools for installation – Paxton Superchargers Mustang Novi 2000 User Manual

Page 5

P/N: 4809610

05DEC03 v2.0 MusGT(4809610 v2.0)

ever rely solely on a hydraulic lift, when
working under a vehicle. Always use
approved jackstands to support the vehicle

and place them under the manufactures recom-
mended lift points.

When lifting the vehicle, make sure it is on a level
surface, preferably concrete or asphalt. The trans-
mission should be in “PARK” or “FIRST”, the
parking brake engaged, and the wheels blocked.

Never start the car with out first verifying that the
transmission is in neutral and the parking brake is
set.

Never remove the radiator cap while the engine is
still hot. Always wear eye protection when using
power tools such as drills, saws, grinders, etc., or
when working under a vehicle.

Never smoke, use an open flame, or have spark-
producing items around gasoline or flammable sol-
vents. Always have a fire extinguisher rated for
chemical and electrical fires handy when working
on motor vehicles.

Run engines only in a well ventilated area.

Carbon monoxide, gasoline and solvent vapors are
colorless, and sometimes odorless. These can
asphyxiate or explode without warning.

Always disconnect at least the (-) negative or
ground terminal of the battery when doing any
electrical, fuel system, or under dash work.

We look forward to hearing from you, particularly
if you have any comments or suggestions regarding
this manual at (805) 604-1336 Paxton Automotive
Corporation, 1300 Beacon Place, Oxnard, CA
93033. E-mail Address:

[email protected]

***NOTE***

Through these procedures the word “discard” is
used periodically in relationship to items that will no
longer be utilized in conjunction with the supercharg-
er installation. It is recommended that these items be
saved for future use should it become necessary.

RECOMMENDED TOOLS

FOR INSTALLATION:

1. Metric and Standard sockets

sets

2. Metric and Standard

com-

bination wrenches

3. Phillips and common screw

drivers

4. 12” crescent wrench or 36mm

open

end wrench

5. Pliers

6. Wire cutters and wire crimping tool.

7. Hose cutters

8. 1/8” drill bit and hand drill

37/64 drill bit

9. Allen wrenches

10. Small heat source

11. 3/8 Tap NPT

12. Air Hammer

13. Air Compressor