Oxmoor RMX-44 - Manual (Page 2)

Oxmoor Corporation, LLC, 309 Cahaba Valley Parkway, Birmingham, AL 35124 USA Toll Free: 1-800-262-6898
Phone: 205-982-8200 Fax: 205-982-8250 E-mail: [email protected] Internet: www.oxmoor.com
RMX-44/RMX-44T & RMX-62/RMX-62T SPECIFICATIONS
Rev. 7.01
FREQUENCY RESPONSE FREQUENCY RESPONSE FREQUENCY RESPONSE FREQUENCY RESPONSE FREQUENCY RESPONSE 20 Hz to 20 kHz .............................................................. +0, -0.3 dB
-3 dB Points, Ref. 1 kHz ................................................... 4 Hz to 70 kHz (+4 dBm Output)
HUM AND NOISE HUM AND NOISE HUM AND NOISE HUM AND NOISE HUM AND NOISE Ref. +4 dBm Output @ Unity Gain .................................... -85 dB (20 Hz to 20 kHz, Unweighted)
DISTORTION DISTORTION DISTORTION DISTORTION DISTORTION Total Harmonic (THD + NOISE)
Ref. +4 dBm Output @ Unity Gain .................................... -80 dB/0.01% (20 Hz to 20 kHz)
Intermodulation (IMD)*
Ref. +4 dBm Output @ Unity Gain .................................... -80 dB/0.01%
CROSSTALK & OFF ISOLATION CROSSTALK & OFF ISOLATION CROSSTALK & OFF ISOLATION CROSSTALK & OFF ISOLATION CROSSTALK & OFF ISOLATION Channel to Channel** ...................................................... -80 dB (20 Hz to 20 kHz)
Driven Input to Off Output ................................................ -80 dB (20 Hz to 20 kHz)
INPUTS INPUTS INPUTS INPUTS INPUTS Type ................................................................................ Electronically Balanced (RF Suppressed)
Connectors ...................................................................... Female XLR
Input Impedance ............................................................. 80 k Ohms
Maximum Input Level ...................................................... +24 dBu
OUTPUTS OUTPUTS OUTPUTS OUTPUTS OUTPUTS Type ................................................................................ Electronically Balanced
Connectors ...................................................................... Male XLR
Source Impedance .......................................................... 150 Ohms (75 Ohms Each Side)
Recommended Load Impedance ...................................... 600 Ohms or Greater
Maximum Output Level
(Ref. 1 kHz @ rated THD)
Terminated w/600 Ohms ............................................ +24 dBm
Unterminated .............................................................. +26 dBu
TRIM POT GAIN RANGE TRIM POT GAIN RANGE TRIM POT GAIN RANGE TRIM POT GAIN RANGE TRIM POT GAIN RANGE Ref. 0 dBu Output ...........................................................
±
15 dB
CONTROL PORT CONTROL PORT CONTROL PORT CONTROL PORT CONTROL PORT Input Type ....................................................................... Active Low, Internally Pulled Up to +15VDC
Input Protection ............................................................... 1/2 Max. Line Voltage, 12 kV Static
Logic Action ..................................................................... Requires Maintained Closure To Common
Connector ....................................................................... Female 25 Pin Std. D-Sub
Logic Levels (At Control Port) ........................................... Low < 3 Volts, High > 7 Volts
Maximum Paralleled Inputs .............................................. 64
Maximum Sink Current .................................................... 50 mA
Maximum Cable Length ................................................... 600m (2000 ft), #22 AWG
Switching Time ................................................................ 100 ms
Power Output .................................................................. +15 VDC
±
0.1 V, 50 mA
TURN ON DELAY TURN ON DELAY TURN ON DELAY TURN ON DELAY TURN ON DELAY Power Up Delay ............................................................... 2 sec
±
0.25 sec
MAINS POWER MAINS POWER MAINS POWER MAINS POWER MAINS POWER Power Requirements ....................................................... 100 to 125 VAC or 200 to 230 VAC
50/60 Hz; 13 Watts Maximum
Fuse Type ....................................................................... 125 mA (1/8 amp) SB @ 115 VAC
63 mA (1/16 amp) SB @ 230 VAC
MECHANICAL MECHANICAL MECHANICAL MECHANICAL MECHANICAL Overall Dimensions .......................................................... 44 H x 482 W x 183 D mm
(1.72 H x 19 W x 7.18 D in)
Finish .............................................................................. Textured Black Paint
Weight ............................................................................. Shipping: 3.8 Kg (8.5 lb) Net: 3.1 Kg (6.9 lb)
ACCESSORIES ACCESSORIES ACCESSORIES ACCESSORIES ACCESSORIES Supplied with unit ............................................................ One DB-25 Male Connector
LISTING LISTING LISTING LISTING LISTING UL & CE
*SMPTE Method; 60 Hz + 7 kHz mixed 4:1. ** Input terminated w/600 ohms, unity gain, adjacent channel driven to +4 dBm output.
Specifications subject to change without notice.