OT Systems FTD100 - Manual (Page 5)

FT100 Series Installation & Operation Manual
www.ot-systems.com 5
(2) Product Overview
2.1 Introduction
The FTD100 Series products comprise of either single-mode or multi-mode fiber optic
transmitters and receiver s for the optical transmission of ONE forward (Tx → Rx) video signal on
one fiber. The products work at wavelengths of 1310nm or 1550nm with either a 9/125um or
62.5/125um fiber for single-mode or multi-mode transmission respectively.
A non-compressed 8-bit digital video transmission scheme is implemented which supports
video in NTSC, PAL and SECAM formats.
For single-mode transmission, we also offer specifically designed products for long-haul
transmissions up to 60km. These models include the letter “L” in the suffix, e.g. FTD100-SSTL for
Tx, FTD100-SSRL for Rx, etc.
The FTD100 Series units are also available as plug-in card modules installed in a
19”
rack-mount chassis. Each plug-in card occupies one slot in the rack-mount chassis. The rack
mount chassis has to be ordered separately, and comes with its own power supply for powering
the installed card modules.
2.2 Models selection table
Mod
e
Model
1
Description
Installation
requirements
Remarks
S
in
gl
e
-Mo
de
FTD100-SST Single-mode 1-Ch Video Transmitter
Card Module
Housed in
FT-C18
chassis
2
FT-C18
chassis has
to be
ordered
separately
FTD100-SSTL Single-mode Long-haul 1-Ch Video
Transmitter Card Module
FTD100-SSR Single-mode 1-Ch Video Receiver
Card Module
FTD100-SSRL Single-mode Long-haul 1-Ch Video
Receiver Card Module
Mu
lt
i-
Mo
de
FTD100-SMT Multi-mode 1-Ch Video Transmitter
Card Module
FTD100-SMR Multi-mode 1-Ch Video Receiver
Card Module
1 If the optical connector is FC type, the suffix in the model number will be “-FXX”. Eg. FTD100-FST
2 Refer to FT-C18 product manual for specifications