Et4111pp series, Installation, Cable connections – OT Systems ET4111Pp-S-DR User Manual
Page 2: Interface ethernet port, Power connector
ET4111Pp Series
Unmanaged Industrial 4-port 10/100Base-TX + 1-port 100Base-FX SFP Ethernet Switch with
PoE+
2
V1
Installation
1.
Connect one end of the Ethernet cables to their corresponding ports on the product. Connect the other end to
the network equipment such as IP cameras, Switches or PCs. Insert the SFP and connect the optical fiber
cables to its connectors.
2.
Connect the product with the power adapter and switch on the product, the PWR indicator should then be ON.
If it is not, please check whether the power cable is connected properly and the power supply functions
normally.
3.
After all cables are connected, corresponding indicators will be on. Please refer to the Operational
Instructions for detail descriptions.
Cable Connections
Signal Type
Cable Type
Connector
Ethernet
Cat. 5 or above
RJ45
Optical
SM/MM Optical fiber cable (depends on SFP)
LC
Power supply
Power cable
2-pin Terminal Block
Interface
Ethernet Port:
RJ45 Pin Assignment:
Pin
Assignment
1
Output Transmit Data +
2
Output Transmit Data -
3
Input Receive Data +
4
Positive (VCC+)
5
Positive (VCC+)
6
Input Receive Data -
7
Negative (VCC-)
8
Negative (VCC-)
Power Connector:
Pin
Description
-
+
Power Input
GND
+48V
(DC)