Dymo LETRATAG LT-100T - Manual (Page 4)

Inserting the Batteries
The labelmaker uses four high-capacity AA alkaline batteries.
To insert the batteries
1. Remove the battery compartment
cover. See Figure .
. Insert the batteries following the
polarity markings (+ and –).
. Replace the cover.
Ç
Remove the batteries if the
labelmaker will not be used for a long
period of time.
Figure 2
Connecting the Optional Power Adapter
An optional 9 Volt,1.5 A power adapter can also be used to power
the labelmaker. Connecting the AC adapter to the labelmaker
disconnects the batteries as a power source.
To connect the power adapter
1. Plug the power adapter into the power connector on the top of
the labelmaker.
. Plug the other end of the power adapter into a power outlet.
LT Momentum AUS.indd 4 19-03-2007 09:12:48