Oklahoma Sound #111PLS - Manual (Page 4)

oklahoma sound power plus lecTern: Model 111pls
4 5
asseMBlY instructions
assembly tips
Assembly of the Model 111PLS is easy and should take no more than ten minutes. Please
read all instructions before beginning assembly. We strongly recommend, to prevent
damage to either yourself or the unit, that a crew of two people be used when moving
the podium on or off your work table.
Parts
(1) reading desk (1) speaker cabinet (fully assembled column)
(1) Base (4) 1¼" Phillips Bolts
(4) Phillips Screws
tools required
Phillips-Head Screwdriver.
i. assembling the Base
1) Gently place the column on a dry, clean work surface.
2) Holding the base with the floor glides towards you, line up the holes in the base with
the holes in the bottom of the speaker cabinet.
3) Starting with the upper left-hand hole, insert and hand tighten one of the 1¼” Phil-
lips Bolts. Proceed to tighten the lower right-hand hole.
4) Insert and hand tighten the remaining two bolts. Finish tightening with screw driver.
Warning — do not over-tighten, just screw until tight and snug.
5) Gently stand the lectern on the floor.
ii. assembling the reading desk
1) slip reading desk over top of lectern. Make sure it slides all the way
down into position.
2) secure reading desk with the four 1¼” phillips screws provided.
connection for optional Battery
white cable from battery cord goes to positive (+); Brass to negative (-).
IMPORTANT do not reverse!
unit dimensions 46”H x 22”w x 17”d; weight 60 lbs.