Dimplex 7206620100R02 - Manual (Page 3)

OPERATION
REMOTE CONTROL
The remote control has a range of
approximately 50ft. (15.25m), it does not have
to be pointed at the fireplace and can pass
through most obstacles (including walls). It is
supplied with one of 2187 independent
frequencies to prevent interference with other
units. The frequency designation is indicated
on the back of the transmitter (FIGURE 1).
A. Remote Control Initialization
This procedure is required every time there is
a loss of power to the remote control in the
fireplace (i.e. power failure, breaker tripped,
main power switch is turned off)
1. Ensure that power is supplied through
main service panel.
2. Access the manual controls, (remove glass
doors if applicable) pull the right hand steel
curtain to the outside of the unit. (FIGURE
2)
3. Locate manual controls refer to FIGURE 3.
4. Activate main power switch, red indicator
light 1 will flash.
5. Press and hold the on switch marked -- for
five seconds. The second red indictor light
will flash.
6. Press ON button located on the remote
control transmitter (FIGURE 1). This will
synchronize the remote control transmitter
and receiver.
B. Remote Control Usage
The remote control operates the fireplace
levels sequentially. The level is increased
every time the ON button on the transmitter is
pressed. The fireplace can be turned off at
any point by pressing the OFF button on the
remote control transmitter.
Level 1: The flame effect is turned on and the first red indicator light is activated.
Level 2: The flame effect remains on, the heater is activated to the low heat
setting (flame effect and purifier only on Purifire
TM
equipped units), and the first
and second red indicator lights are activated.
Level 3: The flame effect remains on, the heater is set to the high heat setting,
and all three red indicator lights are activated.
FIGURE 2
FIGURE 1