NEXCOM NDiS 111 - Manual (Page 29)

Copyright © 2011 NEXCOM International Co., Ltd. All Rights Reserved. 17
Chapter 4: BIOS Setup
NDiS 111 User Manual
Default Configuration
Most of the configuration settings are either predefined according to the
Load Optimal Defaults settings which are stored in the BIOS or are auto-
matically detected and configured without requiring any actions. There are
a few settings that you may need to change depending on your system
configuration.
Entering Setup
When the system is powered on, the BIOS will enter the Power-On Self
Test (POST) routines. These routines perform various diagnostic checks; if
an error is encountered, the error will be reported in one of two different
ways:
▪
If the error occurs before the display device is initialized, a series ofbeeps
will be transmitted.
▪
If the error occurs after the display device is initialized, the screen will
display the error message.
Powering on the computer and immediately pressing allows you to
enter Setup. Another way to enter Setup is to power on the computer and
waits for the following message during the POST:
TO ENTER SETUP BEFORE BOOT
PRESS
Press the key to enter Setup:
Legends
Key Function
Moves the highlight left or right to select a menu.
Moves the highlight up or down between
sub¬menus or fields.
Exits the BIOS Setup Utility.
Scrolls forward through the values or options of the
highlighted field.
Scrolls backward through the values or options of
the highlighted field.
Selects a field.
Displays General Help.
Load previous values.
Load optimized default values.
Saves and exits the Setup program.
Press to enter the highlighted sub-menu