NEXCOM ICES 254 - Manual (Page 85)

Copyright © 2012 NEXCOM International Co., Ltd. All Rights Reserved. 71 ICEK 254-T2 Starter Kit User Manual
Chapter 4: BIOS Setup
SATA Mode Selection
Configures the SATA as IDE, AHCI or RAID mode.
IDE This option configures the Serial ATA drives as Parallel ATA
physical storage device.
RAID This option allows you to create RAID or Intel Matrix Storage
configuration on Serial ATA devices.
AHCI This option configures the Serial ATA drives to use AHCI
(Advanced Host Controller Interface). AHCI allows the storage
driver to enable the advanced Serial ATA features which will
increase storage performance.
Serial-ATA Controller 0
Enables or disables SATA controller 0.
Serial-ATA Controller 1
Enables or disables SATA controller 1.
Advanced
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Enables Legacy USB support.
AUTO option disables legacy
support if no USB devices are
connected. DISABLE option will
keep USB devices available
only for EFI applications.
USB Configuration
USB Devices:
None
Legacy USB Support
USB3.0 Support
XHCI Hand-off
EHCI Hand-off
Device reset time-out
[Enabeld]
[Enabled]
[Enabled]
[Disabled]
[20 sec]
Legacy USB Support
Enable Enables Legacy USB.
Auto
Disables support for Legacy when no USB devices are connected.
Disable Keeps USB devices available only for EFI applications.
USB3.0 Support
Enables or disables USB 3.0 controller support.
USB Configuration
This section is used to configure the USB.