Monroe Electronics Charge Plate - System - model 282CPS - Manual (Page 4)

BATTERY CARE
Both the 282A-1 and 280 use a 9V alkaline battery for operation. Batteries should be replaced when
“BAT” is indicated on the Model 282A meter (7.5 volts.) The Model 280 battery should be replaced when
you can no longer charge over 1000 volts.
CLEANING
It is important to keep the insulators on the adapter clean and free of contaminates that may cause
surface leakage. To test the performance of the adapter plate, charge the plate and note that discharge
rate in a non-ionized area. The self-discharge rate to 10% of original voltage should not be less than five
minutes.
The area around the aperture of the 282A-1 must be kept clean to ensure accurate, drift-free readings.
Never touch the aperture with anything. To remove dust or other particulate matter, use low-pressure
instrument grade air. To remove more severe contamination, spray or flush with the smallest practical
amount of clean technical grade isopropyl alcohol. After cleaning with alcohol, allow the instrument to
dry for several hours before use.
WARRANTY
Monroe Electronics, Inc. warrants to the owners, each instrument and sub-assembly manufactured by
them to be free from defects in material and workmanship for a period of two years after shipment from
factory. This warranty is applicable to the original purchaser only.
Liability under this warranty is limited to service, adjustment or replacement of defective parts (other than
fuses or batteries) on any instrument or sub-assembly returned to the factory for this purpose,
transportation charges prepaid.
This warranty does not apply to instruments or sub-assemblies subjected to abuse, abnormal operating
conditions, or unauthorized repair or modification.
Since Monroe Electronics, Inc. has no control over conditions of use; no warranty is made, or implied as
to the suitability of our product for the customer's intended use.
RETURN POLICY TO FACTORY
Materials returned to Monroe must have a Return Material Authorization number. To obtain a RMA
number, contact our A/V Switching & Control Customer Service at 585-765-2254 or fax 585-765-9330.
Customers have 30 days to determine that the product ordered fills their need and performs as described
in Monroe’s literature. Units returned for approved repair or credit, must be in the original packaging
including all parts and paperwork plus be in very good physical condition. If not, the customer is billed
the cost to refurbish the unit and for missing accessories and merchandise. No products may be
returned for exchange or credit after 12 months of the shipment date. Monroe reserves the right to repair
or replace units under warranty.
P/N 0340111 282CPS/100 Rev 040213
Specifications subject to change without notice.