KLING & FREITAG K&F Line 212-9 - Manual (Page 22)

User's Manual LINE 212-6 / LINE 212-9
KLING & FREITAG GMBH ©2003 - 2005 Version 4.1, 23.03.2006 Page 22 of 37
10. Wiring
The Speaker is equipped with two parallel-wired Speakon connectors.
Before connecting your Line 212 system as shown in chapter 10.3 , be sure to switch
off all connected appliances and turn down all level controls.
− We recommend the use of high-quality cables provided by KLING & FREITAG.
− For connections to the power amplifier inputs, please use 2-pin shielded microphone
cable with high-quality connectors.
− Avoid ground loops (see chapter 10.2 )
− Please pay attention to the respective pin diagrams in this manual!
− To ensure an in-phase operation and, consequently, a homogeneous sound, make
sure that the +/- polarity of the speakers at the amplifier is correct.
− When simultaneously using power amplifiers from different manufacturers, be sure to
use the correct specific pin configuration. It may be necessary to modify the pin con-
figuration on the power amplifiers or on the connectors leading to them.
− To avoid loss of power, the cables should have a minimum wire gauge of 2.5 mm² -
more for longer cabled distances. A minimum wire gauge can be easily calculated
with the following formula:
If several loudspeakers are connected, the signal can be linked through from one loud-
speaker to the next. Please make sure that the total impedance of the loudspeakers R (W)
is not lower than the minimal impedance indicated on the power amplifier.
1/R
1
+ 1/R
2
+ 1/R
3
+ ... = 1/R
total
10.1 Connecting the Speakon Plugs to the Connecting Terminal
2.
1. 3.
1.
2.
Important
Minimum wire gauge (mm²) = required cable length (m)
2 x speaker’s impedance (
Ω)