Interspace Industries MicroCue2 - Manual (Page 13)

13
To reprogram MicroCue 2 , firstly ensure it is plugged into a computer using the
USB cable supplied. Plug a computer keyboard with a PS2 connection into the
PS2 socket on the rear panel of MicroCue 2 (see figure 2). Check the keyboard
can control the computer by using keys as normal. Note that only the standard
alpha-numeric keys will operate. The CTRL and FN keys will not operate whilst
connected to MicroCue 2 in this way.
It can be helpful to have PowerPoint running on the computer during programming
although this is not essential.
Press and hold the Presenter Control button on the front panel of MicroCue. After
about 6 seconds the visual display will cycle through the three handset button
programming points:
Green only on the right of the visual display (NEXT button command point)
Red only on the left of the visual display (BACK button command point)
Amber (BLACK button command point)
Releasing the Presenter Control button at any of these points will leave the system
ready to receive a new command for that particular button on the handset.
Once the system is ready to receive a new command for the button you wish to re-
program, press the key/s on the keyboard to simulate the command you require
(e.g. press the letter ‘w’ to make the screen go to white), then press the Presenter
Control button once more momentarily to store the new command.
Repeat this procedure to program each of the three handset buttons as required.